To Use Devour® Effectively Follow These Four Simple Guidelines

Devour functions differently than other spotting chemicals; it is extremely effective, but special procedures must be followed so as not to interfere with, or stop, its enzymatic activity.

1. Free of Other Spotting Chemical - Other spotting agents may interfere with Devour’s enzymatic action. Therefore, it is important to rinse the area with water or steam gun before applying Devour.

2. Temperature - Warm temperatures speed up the digestion process. Devour’s activity increases with temperatures up to 158° F (70° C). Cooler temperatures slow down the digestion process and a marked decrease in activity will occur below 70° F (21° C). The temperature of steam from the spotting gun or the hot water typical of laundry operations will provide the necessary heat, without being too hot to stop activity.

3. Moisture - Enzymes require moisture to work. If the treated area becomes dry, digestive action will stop.

4. Time - Some stains will respond immediately, but many difficult stains require time for digestion. The actual time required varies depending on the age and type of stain. Allowing enough time for completion of the digestion process is important to enjoying success with Devour.

Direct Application on the Spotting Board

For application on the spotting board, Devour should be used directly from the bottle. Devour contains special wetting agents and penetrants, so it is not necessary to work the digester into the stain with a brush or spatula.

For best results, first flush the stained area with water or steam to remove any other spotting chemicals. The apply Devour directly onto the stain. Warm the treated area with a fine mist of steam by holding the steam gun 4-5” above the garment, being careful not to flush Devour through the garment. If stain does not respond immediately, set aside for 30 minutes. Periodically use the steam gun to keep area wet and warm while the enzymes digest the stain.

After stain is removed, flush thoroughly with steam, then dry before cleaning.

Soaking Solution for Larger Stains

For stains that are either too large or otherwise unpleasant to remove by hand such as blood, vomit and urine, a Devour soaking solution is easier to work with.

To make a Devour soaking solution, mix 1 tablespoon Devour per gallon of warm water in a clean container.

If any other spotting chemicals have been applied to the stain, first rinse them away. Then, soak stained area in Devour solution. Many stains can be removed after about 10 minutes. However, more difficult stains may require up to 30 minutes for complete removal. After the stain has been removed, flush with steam or water, dry, then clean.

For Use in Laundry

For garments that will be washed, pre-treat difficult stains by soaking them in a washer with 1 ounce Devour to 6 gallons warm water. Washer capacities vary; in a typical home-style washer, add 1 to 2 ounces of Devour depending on water level. Allow garments to soak for 10-30 minutes, then add normal amount of detergent and wash as usual.

Devour is safe to fabrics and most colors not affected by water or steam.

It is recommended that Devour be used before the date stamped on the carton. Because Devour contains active enzymes, activity and performance decrease with age. Cool or refrigerated storage will extend shelf life. Keep from freezing.